Just finished installing new clutch (Spec 2+, OEM DMFW). I did this successfully in the past (ACT), but his time I released the clutch bleed valve when installing the slave cylinder (it's easier to compress this way). We closed the valve, then proceeded to bleed the clutch (pump then bleed, repeat).
This worked as normal for a bit them during subsequent bleeding cycles, the pedal got worse until now it has zero pressure. Pedal stays on the floor and has zero resistance. I've gone through a good 5-6 bleeding cycles and it is the same- completely limp, no pressure, stays on the floor.
What could be the problem? There is fluid in the brake reservoir and no visible fluid leaks. I'm stumped.
Thanks,
-TG
This worked as normal for a bit them during subsequent bleeding cycles, the pedal got worse until now it has zero pressure. Pedal stays on the floor and has zero resistance. I've gone through a good 5-6 bleeding cycles and it is the same- completely limp, no pressure, stays on the floor.
What could be the problem? There is fluid in the brake reservoir and no visible fluid leaks. I'm stumped.
Thanks,
-TG