First Drive of the season, no boost. like, 2psi tops.
i sent my MSD80 for mosfets repair (preventative) just got it back, and over the winter I did a LPFP upgrade.
i have tried,
reflash BEF
Updated firmware
vacuum is good, post boost solenoid
wastegates move good by hand, no obstructions
charged system to 20psi, no leaks.
If someone stomps on gas, I see a 8psi target, but, wastegates not moving.
Is there something on the DME that controls that? Or, could my jb4 board be fried?
Any insight?
quick log attached. P32_M1_R1_200505_1451.csv
i sent my MSD80 for mosfets repair (preventative) just got it back, and over the winter I did a LPFP upgrade.
i have tried,
reflash BEF
Updated firmware
vacuum is good, post boost solenoid
wastegates move good by hand, no obstructions
charged system to 20psi, no leaks.
If someone stomps on gas, I see a 8psi target, but, wastegates not moving.
Is there something on the DME that controls that? Or, could my jb4 board be fried?
Any insight?
quick log attached. P32_M1_R1_200505_1451.csv
