Hey @Josh@Cobb doing research on these injector limits we seem to be hitting and it looks like its 100% not a physical limit of the injector flow, but more of a control issue, we need to be able to control injection time etc, I copied and pasted what an actual Conti rep was quoted as saying. How hard would it be to give us more control of the injectors with the Cobb?
"The injectors have a maximum of 40 mg/ms spray at 200 bar. This is an increadible amount of fuel, much much more than any solenoid injector. It is this high, because when we designed the application, BMW insisted that the engine must be able - in limp mode - to only use the LPFP pressure, which is 5 bar, and still drive the vehicle at 170 km/h.
If correct, do you agree then that considering the ti in the compression phase, we can get it up to 4 ms for 7000 rpm ? Can we use the full compression phase ?
You would have to calculate it, but yes, there is extra time at mentioned before.
The injector can inject a lot of fuel into the cylinder. When increasing the injection time, and also when injecting in the compression phase, look out for cylinder wall wetting. This is dangerous. It would wash away the oil on the walls, causing wear. One way to check for wall wetting is to check the engine oil if it has fuel in it. Another way would be to check if the vapor of the exhaust gas recirculation (EGR) and see if there's fuel vapor.
The risk of wall wetting may be reduced by running higher boost, as it affects air flow inside the cylinder.
Running the HPFP at higher pressure may increase the risk again."
"The injectors have a maximum of 40 mg/ms spray at 200 bar. This is an increadible amount of fuel, much much more than any solenoid injector. It is this high, because when we designed the application, BMW insisted that the engine must be able - in limp mode - to only use the LPFP pressure, which is 5 bar, and still drive the vehicle at 170 km/h.
If correct, do you agree then that considering the ti in the compression phase, we can get it up to 4 ms for 7000 rpm ? Can we use the full compression phase ?
You would have to calculate it, but yes, there is extra time at mentioned before.
The injector can inject a lot of fuel into the cylinder. When increasing the injection time, and also when injecting in the compression phase, look out for cylinder wall wetting. This is dangerous. It would wash away the oil on the walls, causing wear. One way to check for wall wetting is to check the engine oil if it has fuel in it. Another way would be to check if the vapor of the exhaust gas recirculation (EGR) and see if there's fuel vapor.
The risk of wall wetting may be reduced by running higher boost, as it affects air flow inside the cylinder.
Running the HPFP at higher pressure may increase the risk again."