Emissions is coming up this week so I put the DPfix in and in the 6PM position when the wires are facing away from you. Install went fine. I've driven around for probably 50 miles at this point and have straight pump gas in the tank. I've done a reset via Cobb and could do more specific resets with the BT cable if that's going to be helpful.
Anyways, today the car decided to throw an SES light along with 4 secondary O2 related codes
P0161
P0141
P2CA9
P2CA8
Believe the first two are heater circuit related (bank 1 and 2). All are related to the secondary O2s so far as I can tell. The car drives fine but it won't pass with all this SES. I haven't completed a full drive cycle yet but the codes re-appear within about 3 minutes of driving.
Any thoughts on this? Before reflashing to STG0 there weren't any codes of any type. Obviously I need to get this taken care of before I go in. Thanks!
Anyways, today the car decided to throw an SES light along with 4 secondary O2 related codes
P0161
P0141
P2CA9
P2CA8
Believe the first two are heater circuit related (bank 1 and 2). All are related to the secondary O2s so far as I can tell. The car drives fine but it won't pass with all this SES. I haven't completed a full drive cycle yet but the codes re-appear within about 3 minutes of driving.
Any thoughts on this? Before reflashing to STG0 there weren't any codes of any type. Obviously I need to get this taken care of before I go in. Thanks!