RB's and VTT Inlets Installed

As the title states, the install of my RB's with VTT inlets was finished up last night. The turbos have the billet compressor wheels, as well as the clipped turbines. As most of the people who will read this know, the clipped turbines should provide more flow up top, while the billet compressor wheel will compensate for the lag that clipping causes (and may add a little more airflow, with the "extended tip" design of the wheel. Ha, just the tip).
Tuning will be done by PTF, and will consist of a pump gas map, as well as a map for an ethanol mix.
I don't have any pictures of the install process, but here are some pictures of the results.















I'll keep this thread updated with tuning progress, and virtual dynos. There will eventually be a real dyno and some 60-130 times, but not until the tunes are finished.
Edit: Apologies for the oil stains on the balancing sheets, they were in the box with the old turbos.

Attached Images