So this week I got the following done:
Tuning Setup
Here are some logs running approximately E60:
Any advice is appreciated.
- Replaced VC and VC gasket
- Walnut blasted valves
- Tapped the 6 intake ports
- Installed AD-Engineering PCV delete and flapper delete (currently venting to air)
- Installed MOTIV Level 1 Port Injection (no FPR, I do have Fuel-It! Stage 2 LPFP)
- Installed SplitSec AIC
Tuning Setup
- Backend: COBB E85 from Terry
- AIC: Port Injection Map A from Terry
- JB4
- MAC_11 Firmware
- Map 6 with 17PSI target across
- FF = 150
Here are some logs running approximately E60:
- http://datazap.me/u/blisstik/pi-fixe...0&data=1-3-4-5
- http://datazap.me/u/blisstik/pi-fixe...1&data=1-3-4-5
- http://datazap.me/u/blisstik/pi-swap...0&data=1-3-4-5
- http://datazap.me/u/blisstik/pi-swap...1&data=1-3-4-5
Any advice is appreciated.